TEMPORARY CONDUCTOR SUPPORT

- RC400-0517
The conductor support can be attached to crossarms, with sizes 
82 x 102 mm to 152 x 152 mm. The C-shaped clamp as well as the wireholder is made of heat-treated aluminum alloy and fixed to the RITZGLAS® tube. It can be installed with the hot stick, and its rated working capacity is 68 daN (150 lb).

-    FLV30058-1 
The conductor support pole (used for lifting conductor cables through its upper head by its lifting wireholder) is adaptable to metal post straps through support with a lower blade.

-    RC400-1509 / RH4809-W
They are used to support energized distribution conductors during pole replacement, repair, or pin or top insulators replacement.

They are equipped with a pole chain stretcher, over Ø 356 mm, and lifting wireholders for conductors up to Ø 25.4 mm (for RC400-1509 with two units and RH4809-W with one unit).

When using temporary support with voltages greater than 15 kV or when supporting energized conductors in the rain (or chance to rain), mounting insulators (RM4805-7) is recommended as additional protection.

Rated working capacity on each wireholder: 68 daN (150 lb).

-    RT400-1939 / RT400-1940
These two temporary support models have the same functions as RC400-1509 and RH4809-W. The difference is the pole mounting system, which in this case coma nylon tie tensioner. (RT400-2007)

The same recommendations for using the insulator (RM4805-7) and the rated workload also prevail for these two models.

-    RT400-2272
The insulator change support is designed for special applications for distribution insulator change, whose conductors are angled.

Used in combination with a nylon strap hoist, it sustains the conductor under mechanical stress during the insulator change and assists the conductor back to its original location.
With this tool there is no need to use round covers or blankets on the pole to insulate the hoist.

To insulate the hoist with a nylon tie, two insulating rods (RC400-1175 or RC400-2399 or RC400-2400) are used, connecting their hooks to the wire grips and their eyes to the hooks of the hoist. 

This equipment was made with Ø 64 mm RITZGLAS® tube, insulating length 0.15 m and working length 0.40 m. It is coupled to the pole using the nylon tie tensioner (RT400-2007).
Its rated working capacity is 907 daN.

TYPICAL APPLICATIONS
Fig. 1 - In this arrangement, the insulator change bracket is installed on the opposite side of the conductor and is used when a short distance from the conductor in relation to the post is required.

Fig. 2 - In this other arrangement, the insulator change bracket is installed on the conductor side in order to obtain a greater distance from it.